User avatar
Lawrence Hubbard

Posted Fri Oct 11, 2019 2:58 pm

I purchased a A1200 from Great Britain. The gentleman removed the HDD and had 3.0 workbench. I purchased a new chip set, installed it. On boot up it shows 3.1.4 which is good. However when I load workbench floppy it calls for LIBS/icon work. No matter what disk I try I get the same message. I also purchased a HDD (CF card 8M) with it workbench on it partitioned with games and demos. It only loads part way; something’s will open, some won’t.

I am trying to find out if there is a hard reset to clear the files that were still there after the original HDD was removed. I have been trying to fix this for almost two months.
Any Help Greatly Appreciated

Lawrence Hubbard
Or email lawrencehubbard.lh@gmail.com

User avatar
McTrinsic

Posted Sat Oct 12, 2019 12:02 am

Is the workbench floppy actually bootabe?

I thought 3.1.4 needs be installed to HDD from the Install-Floppy.





Return to “Hardware”